I can totally blame my friend +Matt Genuardi for this one.
Yes, that IS a 3D printed Baneblade.
It all went together pretty simply. I'm not going to try to detail this one out very much. Just think of it as a 3D proxy!
Other than the random superglue issues, it took about 30 minutes from start to finish. The most time consuming part of the build was sanding down the mounts for the turrets on top of the side sponsons so that they could turn relatively freely.
Matt says these don't look half bad once they are primed, so I guess it is off to the paint booth later in the week! Not that I have even thought of what paint scheme a Baneblade would have in my army...
No comments:
Post a Comment